FREE SHIPPING IN CANADA 🇨🇦 OVER $200* • 1-800-924-1585 • INFO@MOSSLED.COM
FREE SHIPPING IN CANADA 🇨🇦 OVER $200* • 1-800-924-1585 • INFO@MOSSLED.COM
Contact Us About Us Where to Buy Videos News Showcase Gallery
Skip to content
Moss LED FlexLED 96 RGB + White All-In-One 24V spec diagram showing 6.25CM cut length 96 LEDs per meter 12mm PCB and bare wire end

FlexLED 96 RGB + White All-In-One 24V - Temporary Install Grade

SKU I24VRGBW564805060-TIG
by MossLED

Qty Discount
5 5%
10 10%
21 15%
The more you buy, the more you save!
Save 48%
$241.80
$125.94
IP Rating
Colour
Connector Type

Total Availability Total product quantity available to order. Product may ship from one warehouse or both warehouses, if required. If product needs to transfer from one warehouse to the other before shipping, a 24-hour delay may occur.

123 in stock

Location Quantity available at each warehouse location. Orders shipping from a single warehouse ship faster; orders requiring stock from both warehouses may be delayed by up to 24 hours for transfer.

Canadian Warehouse Ships from 1355 Fewster Drive, Mississauga, Ontario, L4W 1A2 Canada : 123 in stock
USA Warehouse Ships from 6405 Inducon Dr W, Sanborn, NY 14132, United States : Out of stock
RGB+White All-In-One Diode in High CRI

This product is Temporary Install Grade as it is above our specification of 23 watts/meter. This product operates at 31 watts / meter with all four RGBW channels at full. Operating this strip with all four channels at full may cause premature failure and require increased thermal management such as installing onto a heat sink.

This product is designed for anywhere high quality light and the ability to change colour is required. It's cutting length of 6.25CM is the closest cutting length for a 24V RGBW product. The white LED produces a full-spectrum of over 95 CRI and an R9 over 85+. 

Suitable for cinema, television, industrial, commercial, hospitality and anywhere high colour quality is required. Indoor and weatherproof strips have TESA 4965 double-sided tape on the back which makes installation as easy as peel n stick. 

This cost friendly RGBW LED is designed to be used for temporary installs such as trade shows or limited run productions. It is not to be used for permanent high-use installations. Warranty on all Temporary Install Grade LED is for 2,000 hours of use.


Soldering Guidelines:
Soldering iron should be between 360°C and 372°C.  Please ensure not to heat each solder pad for longer than 3 seconds otherwise separation of the solder pads can occur.

Pricing is for 5 meters (16.4')

DOWNLOADS

  1. Specification Sheet

  2. UL Certificate of Compliance

Controller, Power supply and Extension Cables sold separately

*nominal lifetime - dependent on installation location

Specifications

⚲